HOME > 사업영역 > Agency > Parker > AC650 Series
AC Drive 부속품
AC DRIVE BRAKING RESISTORS
AND BRAKING KITS
The dynamic braking resistor kits were designed for stopping a motor at full load current from base speed with 6 times motor energy, four stops per hour (NEMA ICS 3-301.62 Dynamic Braking Stop Option).
AC inverters and flux vector controllers use dynamic braking resistors to dissipate excess energy from the DC bus caused by fast stopping or high supply voltages. This can be required even when the drive is stopped so the resistors operate, more-or-less, continuously.
The drive must be ordered with a braking module installed to use dynamic braking resistors.
These reactors are intended for use with the 690+ series three-phase controllers. They may be used when voltage transformation or supply isolation is not required. Consult factory for resistors for older products.
AC inverters and flux vector controllers use dynamic braking resistors to dissipate excess energy from the DC bus caused by fast stopping or high supply voltages. This can be required even when the drive is stopped so the resistors operate, more-or-less, continuously.
The drive must be ordered with a braking module installed to use dynamic braking resistors.
These reactors are intended for use with the 690+ series three-phase controllers. They may be used when voltage transformation or supply isolation is not required. Consult factory for resistors for older products.
- Resistors above 500W are available upon request :
- IP20 protection up to 3 kW
- IP20 protection up to 3 kW
